1500W BLDC Worm Gear Motor, 36V/ 48V

Get a 1500W 3 phase DC gear motor that matches with worm gearbox, which provides high speed and high torque at 36V or 48V power supply, motor dimension 110mm and rated current 52.08A at 36V, 39.06A at 48V. DC worm gear motor is a kind of 3-phase electric BLDC motor with a gearbox that uses a gear speed converter to decelerate the number of revolutions of the motor to the required number of revolutions and obtain a larger torque.

Specifications

Note: Power, Voltage, Speed, Shaft, Motor Length, and Motor Lead of BLDC Motors can be customized.

Allowable Torque with Gear Head

Note: This torque value is the rated output value of the reducer, not the final motor + reducer output torque value T.
Final motor + reducer output torque calculation formula: T = motor rated torque * reduction ratio * 0.6, and T ≤ reducer rated allowable output torque value.

Dimensions (Unit: mm)

Mounting screws are included with the gearhead

Speed-Torque Curve

• Instantaneous maximum torque line
  The maximum torque momentarily impacts the load when the motor is started.
  Beyond this torque, the over-current protection of the driver will cause the motor to stop.
• Short-time operation area
  The motor can run for a short time within this torque range at different speeds.
  If the operation time is too long, the motor will generate heat, which may cause the motor to stop or burn.
• Rated operating torque line
  The rated torque of the motor runs at different speeds, and the motor can run for a long time at this torque.
• Continuous operating area
  When the motor rotates at different speeds, it runs continuously in this corresponding zone.

Tips: How to refuel the worm gear motor properly?

The normal operation of the worm gear motor needs to rely on lubricating oil. When the oil is exhausted, it should be replenished in time to allow the equipment to continue working. During operation, the worm gear, an important internal part, will drive the lubricating oil to run together. In this case, you can always judge the remaining amount of lubricating oil. If the oil level line of the lubricating oil is lower than the oil window 2/3, it indicates that the lubricating oil is insufficient and needs to be added.

However, sometimes, when the worm gear motor is running, it may be different from the actual oil amount when judging the remaining oil amount. In order to correctly determine the amount of remaining oil, it is necessary to observe when the equipment is terminated.

At the same time, when adding lubricating oil, it cannot be added in its operating state but needs to be added in its terminated state.